#RHINO GAS POWERED POST DRIVER INSTALL#
#RHINO GAS POWERED POST DRIVER DRIVERS#
#RHINO GAS POWERED POST DRIVER DRIVER#

Optional 1-3/4 or 1 adapters are also available. Chuck, and Chuck-Lok System with 2 adapter.

Rhino Tool Model 301001 Comes standard with a 2-1/2 I.D.

#RHINO GAS POWERED POST DRIVER DRIVERS#

Comes standard with 1' adapter and lock pin. This innovative post adapter system increases the post drivers efficiency and durability. This innovative post adapter system increases the post drivers efficiency and durability. Includes a 2-1/2 chuck equipped with rhino Chuck-Lok adapter technology.

#RHINO GAS POWERED POST DRIVER INSTALL#

Install commercial grade fence, faster, with less equipment, supplies and manpower.

#RHINO GAS POWERED POST DRIVER DRIVER#

It drives a variety of posts, rods and stakes in seconds, and works with T-posts, form pins and ground rod posts up to 1-5/8'-dia. GPD-40 Fence Pro Gas Powered Post Driver 2-1/2' Chuck. At first my unit would starve after a little post driving until I loosened the cap a bit. Save time, energy and back-breaking strain with the Rhino Ranch Pro Gas-Powered Post Driver. Time will tell how well it will hold up but so far I have had no real problems.Ī hint: If you get one don't overfill the gas tank and don't over tighten the gas cap. I have had to settle for 18' on a couple because they hit a solid rock. I have had to move 1 or 2 because I hit solid rock but other than that all have gone in. So far I have put in about 50 posts and I couldn't be happier. When I found the Rhino I looked at all the videos but was still a bit skeptical, but I didn't really have any other choices, so I bought one. I needed to do some more fencing and wasn't up to using my old slide pounder, it would be more work than I could handle. In the past I have resorted to a hammer drill in places because I couldn't drive t-posts in any other way. Fencing here is very difficult, to say the least. There is no vehicle access to where I am fencing. The country is mostly vertical and side hills. There is some top soil in places, but not much. The ground here consists of broken up lime stone shale on top of solid lime stone shale. We are going to be able to set all of these posts, a 450-foot job, with two guys we are going to be able to set half of them and pound the other half all in one day with no problems at all and still be out of here at a decent hour.I live in S.E. The Rhino GPD-40 Gas Powered Post Driver is very quick and simple. I recommend you use the 2-inch Rhino GPD-30 Gas Powered Post Driver with the light posts and 2 1/2-inch pounder with the heavier one. If you are not careful with it you could damage the top of the post if it’s light tubing.

But you are using light post like we did in this case, it was hard to hold the 2 1/2-inch pounder on the 2-inch post straight and level because there is a little bit of twist to it. In most cases, if you have a heavier post the 2-inch post would probably be fine with the 2 1/2-inch pounder. We also used the Rhino GPD-40 Gas Powered Post Driver on the 2-inch post. It went very quick, very efficient and we loved it. Once it was on the post you didn’t have to do any lifting like with a hand pounder. Reliable Honda GX35 4-stroke industrial engine. The 2.5 heavy wall chuck makes this a perfect choice for driving post up to 2-3/8 outer diameter. It wouldn’t have been too harder with a hand pounder but it was sure nice to have a gas pounder. Rhino Gas Post Drivers are manufactured in the United States for the highest quality and durability. The 2 1/2-inch pounder was very easy to use. We had to walk around trees and stuff like that. By carrying the Rhino GPD-40 Gas Powered Post Driver in with us it did make it a lot easier to walk through the woods. We elected to get longer posts and pound them in.

We would have probably spilled half of it wheelbarrowing it in. With the woods being half of this job, it was much easier to walk in the woods with Rhino GPD-40 Gas Powered Post Driver and bring a ladder than it would be to try and get concrete in, mixing the concrete and wheelbarrowing it in. We are going to set the other ones in concrete like we typically do. Primary Category: Outdoor EquipmentShovels, Tampers, and Digging ToolsGas-Powered Post Drivers 4,424.96 / each. Because of the location of half of this fence that happens to go through a wooded area we decided we would use longer posts and pound the ones in the woods. The 2 1/2-inch post are, of course, being used as our terminal posts. We have 2-inch post and 2 1/2-inch post to install. On this project, we are putting up 4-foot black vinyl chain link.

Rhino gas powered post driver